- SP FLASH TOOL TIMEOUT ERROR UPDATE
- SP FLASH TOOL TIMEOUT ERROR SOFTWARE
- SP FLASH TOOL TIMEOUT ERROR CODE
Recommended Action Try entering the service oir-remove-failing-slot command again. This initialization failed and the service will not be available.
SP FLASH TOOL TIMEOUT ERROR SOFTWARE
Error Message %DBUS-3-ORFS_NOTINITIALIZED: ORFS is not initializedĮxplanation When the OIR Remove Failing Slot (ORFS) feature is configured, the software attempts to initialize parameters. Otherwise, place the PA in one of the supported VIPs and verify that the Cisco IOS version supports the PA. If the VIP that contains the PA is listed as supported, verify that your Cisco IOS version supports the PA. Recommended Action Refer to the documentation of the PA to get a list of compatible VIPs. Error Message %DBUS-3-MSGPAUNSUP: Slot has an unsupported PA in bay Įxplanation The port adapter (PA) in the slot is not supported, either because the VIP is incompatible with it or because the Cisco IOS has no pertinent drivers. DBUS-3 Error Message %DBUS-3-MSGPABADCONFIG: Slot has an unsucessfully configured PAĮxplanation The port adapter (PA) in the slot is not sucessfully configured, either because the VIP is incompatible with it or because the Cisco IOS has no pertinent drivers.
SP FLASH TOOL TIMEOUT ERROR UPDATE
Adjust the data and send it again.Ĭonfirm the status of the network connection, and then update the data again.Ĭonfirm the status of the USB connection, and then update the data again.This section contains data bus (DBUS) messages. The data size to send with the ESC/P command is too large. Try transferring the barcode again after a short time. Make sure the data you transfer does not exceed the capacity of the user storage area. The volume of the data is too large to send.
Register the template with the specified number to the printer.
SP FLASH TOOL TIMEOUT ERROR CODE
This error occurs when printing a template which specifies an incorrect key code, or a non-existent key code in a linked database. jpg files, and then transfer the data again. blf file, make sure that the model name is correct in file and then transfer the data again.Ĭonfirm the size of. blf files, and then transfer the data again. For more information about setting the encryption method of the access point, see the instructions provided with your access point.Ĭonfirm that your printer supports. Set the encryption method of the access point to a method other than WEP, and configure the wireless LAN settings using WPS. If you are using two or more access points, reduce the number of access points to one, and then connect the printer again. Confirm the WPS setting environment (distance between the access point and the printer, presence of obstructions, and so on) for the access point, and then configure the WPS settings for the printer again. Try connecting again.Īn access point for establishing a connection could not be specified. Reconfirm the command and data, and then send them again. Close the Roll Compartment Cover correctly.Ī command outside the specifications or corrupted data was transferred.